STAIRCASE SENSOR CONTROLLER (BTST01)

For more watch this  Video link : https://youtu.be/jig8HYx3GFI?t=124

WIRING CONSIDERATIONS

1. The product is limited to indoor dry environment, strong wind, strong shaking and other environment may cause the induction to fail. The angle is 120 degrees; the induction distance is1 -3 meters, and the induction head being the most sensitive to people.

2.The actual engineering layout line of electrical technology will not be affected.

3.The controller is installed according to the convenient installation position.

THE OAB sensor head needs to be determined by the industry. OAB sensor head can be customized, inevitable can be set)

INSTRUCTIONS

1.Short press the switch once to adjust the LED speed, there are four gears.

The speed adjustment is 100% 75% 50% 25%, the darker the red light means the faster the

2. speed, the brighter the red light means the slower.

Long press the switch for 5 seconds to enter the step number setting mode.

Short press the switch once to set the first staircase,

short presses the switch a second time to set the seconds staircase.

Short press the switch for the third time to set the third step of stairs, and so on, until the actual number of steps required is set.

The controller has a corresponding step blue indicator light, and the blue indicator light is on every time the step size is set. After the above operations is completed, long press for 5 seconds to automatically save the corresponding setting.

SPECIAL ATTENTION TO THE PRODUCT

1. This product is low voltage 12v-24v, you need to connect the transformer and do no directly connect to 220v, so as to avoid three.

2.Please operate the connection of the lamp under the power off. After the operation is completed, first check the lamp and the line before turning on the power. If the lamp or line is not connected properly, it may be short-circuited; resulting in the controller port is burned out.